Sharp Edges Oklahoma

Merry Christmas, Groomers!

My name is Jessie with Sharp Edges in Oklahoma.

Today I want to go over replacing the cord in the Andis 5-speed clipper

Okay, so what you want to do is take out these 4 screws which I’ve already done, flip the clipper like this, you’ll take the top of the case off. And you’ll see here we have a, pull this up, black cord and white cord here.

Pull the white one out. Hold this butt down on this board as you pull up on this which sits on that post. Same thing with the black one. And get rid of your old cord.

Then we’ll come in with the new cord. You’ll want the bottom post, the black wire - this is important - to snap on together. So, we’ll snap that on.

The top post gets the white wire. This is a DC motor, so you want to make sure those are put on there properly.

We’ll put our bale hanger back in here. To set this cord in here, you want to do it with this groove on the topside because it fits into the groove this slot right here on your top case.

Set that down into that groove. You’ll fold your wires down out of the way. Make sure your insulator goes back in there, put that in there like that.

Then you replace the top case.

Make sure it closes up on each side. Flip it over. Put your screws back in.

And that’s all there is to it.

Alright! Merry Christmas! I hope this helps somebody.